RC Draco Dubro Wheels

thingiverse

I designed these wheels to more closely resemble the full scale Draco wheels, while still being fully functional. YOU WILL NEED: DuBro Pneumatic wheels 5.5" (6.0 will probably work, but I haven't tested them) 6x M3x20mm Cap Head screws 6x M3 Hex nuts (non nylock) 4x 5x11x4 ball bearings 1x RC Draco (duh) Print: 2x Draco Wheel Outer 2x Draco Wheel Inner 2x Draco Brake Disk The Brake Spacer provides a very sall mount of resistance while the bearings keep the wheels from chewing up and galling themselvs on the axle shaft. It also looks very scale! (my photos are before paint) DO NOT USE GLUE ON ANY OF THIS This is all bolt together! You also won't need the 5mm washers that the factory wheels use, just the 3mm ones at the wheel nut. When assembled correctly, the wheels should turn freely but keep a small mount of resistance so the model doesn't taxi forever. Also, for best fittment, trim up some of the mess that DuBro leaves inside the tires. I hope this helps someone! Have fun!