Rc Snowmobile Conversion kit (Polaris Rush)

thingiverse

Update Feb 2020, I added the 1 part sprocket because i was sick of seeing people use the unreliabe 2 part one. I also added the v4 track with the reinforced center seam and the v2 a-arms with the two holes option. Also the wheels were missing apparently. They have being added now. Hopefully people will appreciate the small touch! // These are still the free version 1 files, you can get all the latest files here : www.rccreations.shop/shop I figures i would upload things to thingiverse instead of my dropbox. Feel free to share what you make! :) // All printed at 0.2 or 0.3 layer height, 6 perimeters, 4 bottom, 5 top layers, 20% infill, 220 Celsius. // Here is what you need to know to do the conversion : Stuff needed in this kit. Yes electronics is one, but you also need some comon hardware like a 3mm rod (allu or brass), a 6mm rod (30mm long), four 1/8 colars, a bunch of screws(M2,M3,M4...) & washers and a bit of glue and finally, a 16 gauge (1.6mm) wire (rust proof), fense wire works great. The tunnel in made of a thin sheet of steel or aluminium bent and cut. Dimensions in the video Transmission. It uses two 6x13x5 bearings, and two (12x18x4) (*latest files only*). A 56t spur gear and a 14-20t pinion gear from traxxas is used for gears. (look for 56t 32p gear and you should find it...) Also a few m2 and m3 screws will be needed. Electronics, I have in my snowmobile a castle creation Sct brushless combo, a exi steering servo(metal gear) and a spectrum transmitter dx2e and receiver combo. All that coupled to a 3s 2200 mAh from Gens Ace Shocks, for this kit you are going to need two 60-78mm shocks for the front, one 55-60mm for the middle, and one 70-80 mm for the rear. // Here are some of the TOOLS you are going to need to proceed to this operation -box cutter -lighter -screwdriver -magnet (optionnal) -pliers -sheet metal scissors -a candle -ruler -pencil -drill and drill bits -vice (optionnal but really helps) -soldering iron (optionnal)