RC submarine DSRV-1 Mystic

cults3d

NOTE: Thingiverse seems to have problem with downloading models, you'll get "404 error" if you press "download all files". The workaround is to go to the files tab and download the STL's from there, until Thingiverse has fixed the issue. A deep-submergence rescue vehicle DSRV-1 Mystic in scale 1/30 intended for radio control. Designed with ease of printing in mind, along with a high attention to details. Over 1000 individual rivets and bolts! No support needed except for the propeller, the parts are oriented correctly in the stl files for optimal print direction. Specs: Roughly 60 hours of print time and 450g filament. Total length of the hull is 495mm Prop shaft: 1/8" (3mm) Fits 2-2.5" WTC Stand included. Instruction: 1.Print all the parts -Print 8x of the "Rescue hatch support" and 2x "Stand" -Use support for the propeller -You might need to trim off excessive plastic along the corners of the section 2 & 3 parts, so that the lower and upper hull halves close properly. This is important for the lock to work properly. -Depending on the tolerance of you printer, the prop shroud might need some help to get moving freely. I used a 3mm drill bit inserted where the prop shaft otherwise should be, and carefully moved the shroud forth and back to grind off irregularities on the ball-link. -The "Rescue hatch support" might have to be trimmed in length, as it's intentionally slightly too long to compensate for tolerances during printing and assembly. 2.Connect servo linkage to prop shroud To facilitate installation, connect linkages to the prop shroud before gluing the shroud section to the stern section. 3.Glue the parts together -Cut 1,75mm filament in ~8mm long bits and insert in the holes as guide pins for aligning the hull sections. 4.The open the lock holding the upper hull in place, gently insert a piece of 1.75mm filament, or any other >2mm object, through the hole at the center of the hull. Don't push too hard as this might break the lock!