RC10B5m Rear Sway Bar Bracket

thingiverse

I designed an RC10B5m rear sway bar bracket to replace the stock molded bracket, which spit in half, while tightening the mounting screw. Doh! Of course you can't just buy a replacement bracket, only the entire kit :( So I made a 3D printed version! There are 3 sizes of the brackets to work with the 3 different bar sizes in the rear swaybar kit, 1.4 mm, 1.3 mm, and 1.2 mm. Each bracket is sized such that there is little slop between the bar and the bracket. Print 2 copies of each size for a full set of brackets to work with all 3 bar sizes from the rear sway bar kit! Print Settings Printer Brand: LulzBot Printer: Mini Rafts: No Supports: No Resolution: 0.18 mm Infill: 100% Notes: Keep the same sizes bracket together on the print bed, then bag them in pairs, to keep them separated. Post-Printing Clearance the hole You might need to open the diameter of the mounting hole a little so the screw will go though or you can just thread the screw though the bracket and into the rear shock tower. How I Designed This A thin wall of different heights surrounds the flat section of the bracket. This wall keeps the bracket from spinning, locates it on the rear shock tower, and reduces the space between the sway bar and bracket, so the distance the bar can move front to back is minimized, but the bar can still rotate freely.