Real Ghostbusters Proton Pack Cyclotron

thingiverse

tfelty notes: I found tgoacher's cyclotron and wanted to modify it for a Real Ghostbusters pack. <b>So big shout out to him on this. He did the work, I'm just putting holes in another spot.</b> <b>Also I've not printed this yet. I'm trying to do a virtual build first and then when I'm happy I'll print the pieces. If you do a print post picks as makes and give comments. Want to know how this goes for everyone else. Also the bumper is not included in this pack. Its cribbed from https://www.thingiverse.com/thing:87161 so props also to loughkb. Check out the remixes because it seems people have been playing with the middle piece. </b> I've modified the top pieces to have the hole in the middle of the bottom covers. To fit the LED holders in, you can either modify the models farther or my plan is to cut the part that collides. To Build Print the following: Print two copies of CyTopWide.stl Print two copies of CyBottomWide.stl Print two copies of CyBottomNarrow.stl Print four copies of CyDisk.stl Print one copy of CyTop_rgb_left.stl & one copy of CyTop_rgb_left.stl - <b>Note: I'm an idiot. I created a left and a right, but you can just print 2 of one of them. You'll just have to flip it over. Or print 1 of each, I don't care. </b> Optionally print 3 copies of LedDiffuser.stl in clear PLA. This fits a 5mm LED. From tgoacher's project: UPDATE 2/12/17. This part was used in the Ghostbusters Station 6 fan film. Check it out on youtube at https://www.youtube.com/watch?v=RHMUsQqLmRg RE:UPDATE 4/12/15 New mount will need holes for self tappers to be drilled into the bottom of the cylo. I will make changes to fix this soon. UPDATE 4/12/15: New cyclo mount added. This is an improved, single mount over the 4 separate ones previously and aligns with the holes in: https://www.thingiverse.com/thing:1093376 I need to update the cyclo bases to match the holes in the mount, or in the meantime, use a 2.5mm drill with the mount against the base of the cyclotron as a drill template. A full size, 3D printable version of the Ghostbusters' Proton Pack cyclotron based on Steffan Otto's plans at: http://www.gbfans.com/wiki/Stefan_Otto%27s_Prop_Plans Print two copies of CyTopWide.stl Print two copies of CyTopNarrow.stl_Replaced with RGB Versions Print two copies of CyBottomWide.stl Print two copies of CyBottomNarrow.stl Print four copies of CyDisk.stl Optionally print 4 copies of LedDiffuser.stl in clear PLA. This fits a 5mm LED. Join bottom parts together using M4 nuts and bolts. Push CyDisks through CyTop holes, then fasten to CyBottom from underneath with 5/8"x#3 self tap screws. Print drill.pdf onto A3 paper at 'actual size' for the drill centres for holes. Print 1x CyBottomNarrow.stl and 1xCyclo-NFilter if you plan to use my N-Filter at: http://www.thingiverse.com/thing:543816 UPDATE 20/11/2014: Added pillars to allow the cyclo disk to fasten directly to the motherboard. See CAD rendering for details.