Real or Fake Head lights for RPM Front Bumper on Traxxas Slash

thingiverse

I designed these headlights that I call real or fake headlights as a cosmetic upgrade but they can also be used to install real lights in case someone wants to do that as an option if you wish to download these files you will need three screws They need to be about 3x20mm. And also you will need some super glue. I need to tell you depending upon the 3D printer that you use you will need some sandpaper to sand out some of the rough edges and also some drill bits of the right size to get some of the excess material out of the holes so the screws will be able to go through the holes easier, and also do the same thing with the other holes that where the lights are going to go into. And as you see in the photos they should give you an idea how to assemble and install them so enjoy the files. But I need to tell you that the files that I will give you is a redesign of this component that you saw in the photos why because when I was installing this component that you saw in the photos I ran into an issue in regards to the two holes on the left and right side where the screws on this 3D printed component. As a result I needed to widen the holes up a bit so I will have an easier time getting the screws through the holes so I have an easier time installing this on to the front bumper so what you see in the cad files that's a two holes on the right and left side or a bit wider than the one in the middle I did this so when the next person downloads the files and tries to install this on his or her rc vehicle they wood have an easier time installing this component and hopefully they will not need to make a wider hole and they need to. So I need to warn you about that.