Rear Mount Cooling Blower Fan Duct for FlashForge Creator Pro - Remix/Mashup

thingiverse

This is a remix combination of the two things linked below. I wanted to use a blower style fan but the duct for that one had too little clearance and I didn't like the output so I mixed both together and came up with this. The only support I had to add was under the pin that holds the blower fan on and also in the slots where the M3 nuts go to ensure the screw opening was good. I use Simplify3D so it was very easy for me to add supports only where I wanted them. http://www.thingiverse.com/thing:577557http://www.thingiverse.com/thing:1304044 The fan fits nice and snug and I tested and could not hear any vibrations. The original duct (http://www.thingiverse.com/thing:577557) supplied clips but I found that they fit loose on my Creator Pro so I designed my own, you may want to try the original clips and the ones included with this upload and see which ones fit best. You just need some M3 screws and nuts which there are several extras in the hardware bag that comes with the FF Creator Pro. One note, if your creator comes with a back plate behind the build platform you will need to remove it or it will hit the installed cooling duct. There is plenty of clearance with the back plate removed. Print Settings Printer: FlashForge Creator Pro Rafts: Doesn't Matter Supports: Yes Resolution: .15 mm Infill: 15 % Notes: Very few supports needed, only where the M3 nut openings are and under the pin that holds the blower fan on.