Redcat Gen8 no-bump skid plate, reinforced

thingiverse

28/2-2021 Edited just two holes that was a bit too big, that's all. This is a remix of drozd79's excellent part. But I managed to break the upper rear tie rod mount, and it looks like it was too thin. I see he has uploaded a reinforced version. But with that the tie rods gets mounted 4mm further out, and to me it looks like they will clash with the fender side guards. I liked the original Redcat version better, with that you also get the two rear mounting holes for the battery tray. On drozd79's version these were gone. You need support only under the two "bridges". Cura adds support under the small bosses in each corner, but they get so small that they are hard to print. I used support blocker on them as they print fine without them. I use three walls for strength, and 40% infill. I read that more walls are better than more infill. Thomas