RelayCase

thingiverse

This is a project that requires a relay board. This component can be used with one of my designs (Adapter) as shown in the pictures I've uploaded. Links: Adapter (1): https://www.thingiverse.com/thing:3776710 Relay board (1): https://www.amazon.ca/SunFounder-canaux-Arduino-2560-1280-Arm-Stm32-Raspberry/dp/B00E0NTPP4/ref=sr_1_3?s=gateway&sr=8-3 Terminal block (6): https://www.amazon.ca/100-pcs-Pole-Mount-bornier-300/dp/B07D71JNQD/ref=sr_1_14?s=gateway&sr=8-14 Instructions: 1. To secure the adapter in the case, you will need four M5 screws with nuts. Simply encase the adapter at the back of the case and screw it into place. 2. Create wires that can be plugged into the relay board and welded to the terminal block. 3. Insert the terminal blocks into the holes at the top and bottom of the case, then weld the wires to the terminals blocks. 4. Secure the relay board in the case using M3 screws and plug the wires into the relay board. 5. Place the cover on the case and you will have a functional relay case. Note: I am not responsible for any problems that may arise from using this product. Make sure to assemble it correctly before use, as a poor assembly can cause a fire. Enjoy!