Remix (BIG version) of the Snap-Together Mini Minecraft Jack-O-Lantern

thingiverse

This is a remix of the awesome Snap-Together Mini Minecraft Jack-O-Lantern with integrated LED by Scottrlindsey, the major difference being the size and that this is made to put a large remote controlled LED into the base. This is a bit half baked still since it did not snap together easily, and I will probably need to glue the base to the top. There are also gaps where the parts meet between the top and base. It would be better to make it all one piece however my 3D program cannot convert models > 3000 vertices to solids so I was not able to work with the top part. Despite the problems, with Halloween right around the corner, I thought I should put it up since it does seem to work, just not as perfectly as it should. It is very much a work in progress, but I am not planning to do more with it since Halloween is in a few days. To print this, use the parts here, along with the following from the original, but they will need to be scaled up: Top - scale by 337% Stump - scale by 320% The parts posted here do not need to be scaled up, only the original parts need to be scaled for this. The Ghast diffuser is not needed, and I have yet to print the bottom part of it. If the bottom part of the diffuser is used, it will need to be installed prior to snapping the top and bottom together since it will not go in otherwise - I am leaving it off mine since it is just a hassle to deal with it (so I am only using the top part of the diffuser). I printed with supports (everywhere) and used 0.25 layer height only since I had a 0.3mm nozzel fitted. The parts will need to be arranged for minimum supports, so put the nose flat and flip the Ghast upside down. This was designed to work with these LED lights: https://www.amazon.com/gp/product/B07HM7SG1L