Remix Duplicator 9 Bed Leveling Knob

prusaprinters

<p>This is a bed leveling knob cover that is a simple remix combining 2 different models to work for the Duplicator 9.</p> <p>I created a second version (v2) that is smaller to make sure there is enough clearance around the stabilization bar and the aluminum upright on the right hand side. I recommend that version to make sure there is clearance.</p> <p>The creators of the original models are the ones that did the hardest work I only did modifications to them and combined them. I left a pattern near the center so that the original design work on <a href="https://www.thingiverse.com/thing:3145976">http://www.thingiverse.com/thing:3145976</a> , where one notch is equal to 0.05 mm Z height will still apply. That design hints that 1 turn is 0.5 mm. The arrow tire mark on the side also indicates the direction to make the bed go up.</p> <p>If this is too tight, you can just heat it a little with a hair dryer to make it slide on easier. Don't heat it too much though or it might get too lose. It was a little tight on the wheel but I purposely left the original design dimensions as you want it to be a little snug.</p> <p>** If you have the stabilization bars upgrade or little clearance with the back right upright aluminum, the bigger v1 leveling knob might rub against them so use the version 2 (v2).</p> <h3> Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p><p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div><strong>Resolution:</strong></p> <p>0.2 mm</p> <p><p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div><br/> <strong>Filament:</strong><br/> Sunlu PLA Red</p> </p></p> Category: 3D Printer Parts