Remix Duplicator 9 Bed Leveling Knob

thingiverse

This is a bed leveling knob cover that's a simple mashup combining two different models to work for the Duplicator 9. I came up with a second version (v2) that's smaller, ensuring there's enough clearance around the stabilization bar and the aluminum upright on the right-hand side. I highly recommend using this version for optimal clearance. The original model creators put in the hardest work; I simply made some modifications to their designs and combined them. A pattern near the center remains intact so the original design work from http://www.thingiverse.com/thing:3145976 still applies, where one notch equals 0.05 mm Z height. This design suggests that 1 turn is equal to 0.1 mm. If this cover feels too tight, you can just heat it up a little with a hair dryer to make it slide on more easily. However, avoid heating it too much or it might become too loose. It was slightly tight on the wheel, but I deliberately kept the original design dimensions so that it's a bit snug. **If you have the stabilization bars upgrade or minimal clearance with the back right upright aluminum, the bigger v1 leveling knob will likely rub against them; use the version 2 (v2) instead.