Remix of Decorative Butterfly

thingiverse

:::: Thanks to (UPM_Formi_3D) (https://www.thingiverse.com/thing:2843948) for his original Decorative Butterfly Files. I remixed the body 2 ways. 1. A simple hole on the bottom for a little screw or nail mount. 2. Hole inside the body for you to drop a magnet into. The hole is about 13mm wide and 3.5mm deep so a 12mm x 3mm magnet would be perfect. For you to drop the magnet in you have to pause (or do a filament color change with out the change) you just need to stop the printer at 4.2mm right before it does the next layer to cover the hole. I also put in a drop of epoxy glue in the hole before dropping in the magnet and pressing it down, the glue will hold the magnet in place. If you use a strong magnet it will attach to the nail or screw that was used to attach the sheetrock to the wood stud in the wall. Nice part is that you can move them around the room/house and not leave any screw holes in the wall after you move it. This only contain the 2 remix butterfly bodies, you still need to download the wings from https://www.thingiverse.com/thing:2843948