Remix PKD Bladerunner blaster bolt and handle

thingiverse

If you have a resin printer with enough height (prints great on Mars 3 with room to spare), having a combined bolt handle and bolt for the blaster makes for easier work. Also, if you are using a non-tough resin, the handle is a weak point if and can snap off. For those reasons, two models. Non-pin version is just a combined bolt handle and bolt with the original alignment holes filled. Pinned version has holes for 2 1/16" pins, likely you should cut down longer ones so that they are 1-2mm counter sunk into the holes and just put a couple of drops of printing resin to cover em up before finishing. I recommend warmed two part expoxy on the SIDE of the pins prior to inserting.