Remixed axle gears for ease of printing and less skipping

thingiverse

Remix gears designed to be printed with a 0.4mm nozzle. Not only they are easier to print but the gears don't skip. Same gear ratio, just bigger and less teeth. P7_G17_0.3 gear is 0.3mm longer. Print that one first. If you have problems or after screwing the cover there is too much friction you can print the other one. I have both versions installed one in the front and one in back axle. Actually what causes the friction is the thichness of the teeth of the small gears. As I wrote just sharpen them a little bit with a knife. Printed with PETG on an ender 3 v2. Line width 0.4mm layer height 0.2mm. Print speed: 15mm/s. Bed and nozzle at 80/235C After you print the small gear sharpen the teeth a little bit with a knife