Renault Clio 3 Trunk Clip

thingiverse

# Clio 3 Trunk Clip The design this clip was remixed on was a bit too small for the plastic attachment of the trunk cover (probably a Clio 2-3 difference). Also the clip kept falling out of the attachment to the trunk itself due to wear of the plastic on the car itself. I tried to improve the design for both things by increasing the diameter of the head (11.5mm to 13.25 mm, snug fit) as well as adding a screw to hold it in place. The result is very sturdy attachment for the trunk cover, enjoy! # Materials - PLA 3D print (other materials also possible, not tested though) - M2.5 20mm nut and bolt # Settings Print: 0.2mm layer thickness, 20% infill, no supports needed Plastic: Prusament PLA Galaxy Silver Design: Fusion360 Printer: Prusa i3 MK3S