Renault Megane GT Automatic Gear Releaseknob

thingiverse

This is a selfmade model of the release-knob of the Automatic-Gear-Stick fitting for the Renault Megane 4. The shaft-hole-ribs are thicker than in the original part, so they should work longer than the original ones. I printed it in PLA, ABS and PETG, just as a test, and it worked well. I tried also, to cut out a piece of the two rings, to clip the switch-button over the pin, to avoid disassambling the complete gear-stick-head, but the result was unsatisfying. The stick-head is easy to unmount and than it's also easy to mount the new switch-button..... round about 120€ saved :-) On the last foto the switch is shown in PETG red trans... looks also interesting :-) injoy it.....