Repetier 1.0.2 for RAMPS 1.4 TronXY X5S

thingiverse

my repetier 1.0.2 for ramps 1.4, 32 step drv8825 drivers, 2:1 ratio 2mm pitch single z motor, 3:1 ratio direct drive extruder, normally closed style endstops. Adjust in Configuration.h your steps per mm based on your own calculations for your stepper motors/idler tooth count/lead screw pitch. If you are using the stock endstops then you will want to set the inverse value to true. steps per mm for x and y if using stock motors and 20t idlers would be 160 steps per mm for 1/16 set stepper driver or 320 steps per mm for 1/32 step drivers an so on for 64, 128, 256 step drivers. use at own risk. parts I'm using for my setup https://www.thingiverse.com/thing:2870184 https://www.thingiverse.com/thing:2755942 https://www.thingiverse.com/thing:2720038