Replacement handle for fridge or freezer

thingiverse

Replacement part for freezer handle. Did that 2 years ago now. And it still holding (more than my expectation, since the original part broke quite quickly, and was in sound, solid, hard plastic). So it might help someone else. It was designed for my freezer, obviously. But it is customizable (using customizer, or OpenScad) to adjust screw position, length, etc.) The shape is not at all the same that the original one, but I tried to make it usable and not too much cubic :) It should be printable without support. As you can seen on my picture, the top part went out a little bit messy on my printer. But that is a leapfrog creatr, an expensive but very basic printer, without a fan for cooling filament, and I printed with a very thick .3 layer. So, chances are, one your printer it will come up just fine. Otherwise, use support.