Replacement landing gear for Hoverthings Flip quadcopter arm

thingiverse

This is an OpenSCAD knockoff of the lightweight landing strut for the original Hoverthings Flip frame. If you break one, as I did, you can print a new one that will barely be distinguishable from the originals. The stl here is very close to original size. If you want to modify the design - make it longer for more ground clearance say, or beef it up, then you can do so with my OpenSCAD file. There are variables for the arm slot dimensions and total height, so it is somewhat scalable, but you may need to adjust the cutouts if you vary the defaults by much. Enjoy. The photo shows the original piece on the right and printed version on the left. Support Hoverthings. They make great stuff.http://www.hoverthings.com/ Instructions Print this in ABS at 100 percent infill. Layer height doesn't matter much. A quick and easy print.