Replacement Sleeve for a stable Microphone Arm Stand

prusaprinters

<p>I got one of those cheap microfone stands that you can clamp on your desk, and where the arm and the clamp meet there's very bad plastic sleeve that has way too much play. I designed this sleeve that has a very tight tolerances so it rides smoothly 360 degrees without any play, and goes all the way through so it is stable even without the tensioning screw, which helps save space behind your desk.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Graber i3</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div> <p><strong>Infill:</strong></p> <p>100%</p> <p><strong>Filament:</strong></p> Generic ABS <p>Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>I printed it with ABS</p> Print it facing down. <p>Infill: 100% Concentric</p> <p>0.2mm layer height</p> <p>Use 5mm brim (if you have weak bed adhesion)</p> <p>The fit is VERY tight, and rotating will be hard for the first time, it will loosen over time and rotating will become very smooth once the plastic polish itself up.</p> <p>If your printer makes undersized hole, it will NOT fit!</p> <p>My printer leaves a bit of elephants foot so I had to sand the opening of the hole a little bit to make the shaft fit.</p> </div></p></p> Category: Audio