Resqme visor clip remix

thingiverse

This is a remix mash-up inspired by https://www.thingiverse.com/thing:2359947 and merging https://www.thingiverse.com/thing:1792579and https://www.thingiverse.com/thing:2792852 I like the visor mount but wanted to use the keychain as a means of removing the ResQme from the holder. With the visor mount as is that inst possible. Using berky93 thing along with DREIDK's very handy sunglasses visor clip I'm looking to create that type of mount. The idea, if it works, is to have the mount on the left or right side of the visor so when you pull the keychain the mount binds to the visor and out pops the ResQme Not keen on the amount of support that is required but not able to figure out a way to print it without supports That's the plan, will see how it work in practice Don;t think this will work printed as one piece. Due to the only possible orientation the curved/arched section that holds the ResQme is printed with horizontal lines going the full width. The moment you insert a ResQme it snaps :o( v2 will printed in 2 separate parts that need to be glued together using epoxy - not my favorite solution Also just noticed that on my print of RESQME Car Escape Tool Mount by berky93 that is isnt quite wide enough to accommodate the tool without deforming the base. Which will be another reason the curved part snapped on my version. Will slightly extend the holder part and see what that does v2 width has been extended to stop the base deforming, making the curve section snap off - not printed that as yet. Testing just the tool holder section for now ***Update*** Have abandoned previous version as it keeps snapping due to print orientation V3 works perfectly 3 slightly different visor widths