ReStore Chair 1

cults3d

This chair was created as a test model for our pellet printer, GBX, and to test pilot a collaboration with Habitat for Humanity's ReStore. We used 2x2 scraps from ReStore and recycled plastic to create an outdoor chair! It can also be printed using a regular extruder. There were no fasteners used in this design, masking tape was wrapped around the ends of the wood to create a tight fit, then there was a bit of wood glue for good measure. There were only a few of these made as we switched up the design to one which uses fasteners. That way, when the end of life of the chair has been reached, the sides can be ground up again and re-printed with.