Revised Apple Watch Classic Charging Dock Insert

thingiverse

<h1>Overview</h1> Remix of ['Apple Watch Charging Dock - Classic Mac'](https://www.thingiverse.com/thing:1216409) by [Option8](https://www.thingiverse.com/option8) The charging insert has had the top chopped off it to allow for printing without supports. <h1>Print Settings</h1> <h2>Quick Guide</h2> | Setting | Recommendation | ---------------- |:-------------:| | <i>Resolution:</i> | 20 mm / 200 micron | | <i>Infil:</i> | >20% | | <i>Supports:</i> | Not Needed | | <i>Adhesion:</i> | Depends on material, raft if needed | | <i>Print Speed:</i> | Medium | | <i>Fan Speed:</i> | High | | <i>Material Type:</i> | Any Rigid / Non-Flexible| <b><h2>Optional</h2></b> <b><h2>speed</h2></b> You can print at a lower resolution however this insert is not seen and lower resolutions will take longer to print. You can print at higher resolutions but the cable guide may not fit. <b><h2>Infill</h2></b> Infill should not matter as walls should be thick enough to result in a full model. If not infill of 20% should be more then enough. Any infill pattern will do so choose your favourite! <b><h2>Supports</h2></b> You should not need any supports to have a functional print. There are some overhangs however the modified insert has removed the section of overhangs that will cause issue with the chargers fit. If you want a print that looks perfect you could print with supports however the area this improves will not be visible in use. If you have a printer or material that particularly struggles with overhangs I recommend using supports <b><h2> Adhesion </h2></b> You should not need adhesion if you have a heat bed and low warp material. If you do not have a heated bed or are using a material prone to warping I recommend adding <b><h2> Print Speed </h2></b> Printing to fast will cause problems with overhangs. As it is a quick print I recommend not pushing the speed above what you would consider medium for your printer. <b><h2> Fan Speed </h2></b> A higher fan speed will result in better overhangs so I recommend 100% If you have a material that requires a lower fan speed use that. <b><h2> Material Type </h2></b> You should have no issue printing with any rigid non flexible material type. You may be able to print with flexible materials however I have not tried this. It will likely improve the cable clip but the insert may not fit well due to bend with the weight and magnets of the charging dock.