RF1000 Idler with lever
thingiverse
The normal idler did not have any way to pull it. If a low spring tension would be enough to push filament through the nozzle then you wouldnt need that. But printing at lower temps its always better to tighten it up! Well but then when pushing in filament its very hard so Ive done this. Print in ABS or higher temp filaments, the "coldend" gets very hot after all so PLA wont work ;) Have fun Print Settings Printer: Renkforce RF1000 Rafts: No Supports: No Resolution: 0.2 Infill: 100% Notes: Printed in HF-ABS: 40mm/s 0.5mm extrusionwidth 0.2mm layerheight 100% Infill 2 Perimeters 235°C
With this file you will be able to print RF1000 Idler with lever with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on RF1000 Idler with lever.