Right Angle Manual Implant Driver

cults3d

Attaches to a regular E-type slow-speed hand-piece allowing the dentist to conveniently insert or remove the abutment screw when the access hole is difficult to reach with a regular implant driver. Print one for every operatory! This is not intended as a torque wrench, and your maximum torque will depend on what material you print it with. Testing showed approximately hand-torque capacity between 10-15 Ncm with PLA. Excessive torque to insert or remove the screw will damage the 3D print. Download has long and short handles included for your preference, as well as pre-hallowed versions with drain holes for resin printers. This has only been tested with FDM printers, so your feedback is important for ongoing improvements.