RigidBot Part Fan

thingiverse

I created a fan mount for my RigidBot single extruder (it probably works on a double too). I really like it because it keeps the fan out of the way. The bracket gives just enough space to hit the tension lever with a screwdriver and secures down using the two screws that hold the bearing. It's designed to work with this fan: http://amzn.com/B00H8VV0XK, but other fans might fit too. The duct does a great job and doesn't blow on the hot end enough to make any difference. It snaps into place easily, but I don't completely trust it so I used some tape just in case. Lastly, the fan mount rods have a hole near the end where you can put a pin or bar to hold the fan securely - I use a rubber band and it works perfectly fine. I recently updated this fan mount (10/2016): Fixed scaling issues now. It should print correctly without any need for adjustments.