Rimzler Dison Camera and GoPro Mounts

thingiverse

I needed a couple camera mounts for the Rimzler Dison I printed, so I created these two. The first mount is for a GoPro Hero 5 Session with the "Rubber Suit" from here https://www.thingiverse.com/thing:2594062. This is a ZERO Degree mount meant for non aggressive flying. The second mount was intended for my Runcam Swift Mini I had laying around. The mount has a 22mm spacing and should work with many other 22mm wide cameras. There's a hole in the rear of the mount that is meant for a bolt to go through where the rear of the mount sits over the lower strut between the two front ducts. You don't have to use the hole and a bolt, but, you'll have to drill a hole through that strut in order to bolt it in. I'm assuming that whoever uses this feature printed the frame at 100% infill like you are supposed to.