Ring of Power

thingiverse

Forged In the land of Mordor, in the fires of Mount Doom; one ring to rule them all and in the darkness bind them. A modular ring of elfish design; the gem can be printed and attached separately. Instructions Print the ring base or full ring with the ring on its side (rotate 90 degrees so the hole is parallel to the ground plane) and print with rafts but no supports. You can print the ring out at various sizes to fit your finger - trial and error. The gem print can be superglued onto the ring base - one hint is to print the the gem slightly reduced size so that it fits inside the ring base better otherwise it sits on top (perhaps 5% smaller than the base). This probably prints best at 100 micron layer height or better because of the intricate branching on the sides of the ring. Made in Modo - derived from base ring model.