RJ4JP-01-08 Bearing Clamp - Tighter Fit

thingiverse

Base Part: All I did was bring user 3Displacement's bearing clamp for the smaller RJ4JP-01-08 drylin bearings into TinkerCAD and smoosh some small rectangles on the inner track to narrow it (evenly) toward the center. My drylin bearings were maybe smaller than most? Iunno, in any case they were still rattling around by about a mm or two so I had to narrow the track a wee bit. Inset Clamp Part: I only had M3 screws of just above and just below the "flush with the bottom" length, so I just "inset" (deepened) the screw placement holes a bit to accommodate shorter M3 screws. Big thanks goes to user 3Displacement for the design in the first place, as I'm super stoked to have a lighter X-axis now.