Robo 3D ViKi mount

thingiverse

I'm tired of having my LCD on the floor or on a shelf when it could just as easily be mounted to the Robo 3D. This is my relatively crude attempt to make a case off LCD mount. Technically, with a long enough screw, this works with the case on. I printed mine at 10% infill, 0.3mm layer height. Because this piece has long straights, it's a good part to test high speed printing with. I printed the Bezel at 90mm/sec. To install, Bolt it to the Robo, stick the tab down with sticky tape and mount the LCD.