Rockwell Style axles

thingiverse

This is a Rockwell style housing for the HG BX-02 and BX-03 that came on the HG p401 and p601 . These are 2 halves that replace the stock ones, uses everything else don't recomend printing any lower than 0,2mm and had good results in printing with the flattest face on the bed, brim is necessary I did all the design with the rear axle parts. Tried to mount the front c-hubs but it's needed to shave a small lip on them. You'll see when you get there. Supposedly,SCX10 CVDs and universals are direct fit on this axle, if so, there's a steering improvement update: modified the Rockwell1 file to be also able to house the gear of the pass-though shaft Please leave feedback on the comments