Roll Holder on Delta Printer

thingiverse

Roll holder to use 3 bearings for smoother filament extrusion on a Delta Printer. Due to different roll sizes I created it to use rings for gap fillers. I also created an extended outer ring as my bolt was to short. Print Settings Printer: Micromake D1 Rafts: No Supports: No Resolution: 0.2mm Infill: 15% Notes: I created it so when holes reduced I used a 0.2mm (one layer) over the hole. This helps to reduce the use for supports and create a better layer. I printed at 0.2mm with 0.3mm first layer and 0.8mm side, top and bottom walls and 15% fill density. How I Designed This Software Used FreeCad for the design and Cura for printing.