Roll Support for Spools - Ender 3 - V2

myminifactory

Version 2 (V2) I made a smaller version, so now it fits smaller spool holder holes.It fits as low as a internal spool holder diameter of 56mm If you like my designs, please support by tipping me. Even $1 is fine :) https://paypal.me/bmabma ---------------------------------- The original spool holder of Creality Ender 3 has a diameter (30mm) too small in comparison to the spools i've been using (74mm) so I did this support. There are 2 supports that are clamped to the original spool holder, and each one has 2 rolls on the top that make contact with the spool. No need to use bearings, bolts nor any extra part, just print it! I used 0.2mm of layer height, 0.20 infill and tree supports You need to print: 2x Roll support for spools - Ender 3 - CLAMP 4x Roll support for spools - Ender 3 - ROLL   https://www.youtube.com/watch?v=WHJQXTCmQHY