Roll-Up Rose for Small Print Bed (Prusa Mini+ / 180x180mm)

prusaprinters

<p>Sharing these files to make it easier for anyone with a small print bed who wants to make one of these roll-up roses. Overall, the model is scaled down 80% with a minor modification to the thickness of the rose petal part.</p><p>Follow the same instructions as on the <a href="https://www.prusaprinters.org/prints/131746-super-realistic-rose-roll-up-design">original rose</a> model page.</p><p>The center of the rose was the only file specifically modified as a brim wasn't enough to stabilize it during printing. Remove the additional square of material from the bottom of the pin after printing.</p><p>Notes:</p><ul><li>I found that using super glue to keep the petals wound up was necessary.</li><li>At this scale, the rose is a bit top heavy, so using a heavier/taller vase or shortening the rose stem might be a good improvement.</li><li>I used <a href="https://www.prusaprinters.org/prints/70448-giroid-vase">this vase</a> scaled down to 40mm diameter.</li></ul>