Roller skating slalom cone

thingiverse

Cone for who likes to work out slalom skating This cone has been designed to support high air flow, it supports a wind until 30Km/h You can customize the 'wall_size' var to get a harder cone, but read the following considerations: - I tested it 0.8mm 1.2mm 1.6mm and 2.0mm and PLA - 0.8mm and 1.2mm breaks easily with any hit - Better wall width is 1.6mm but the infill configuration in the slicer is important: For a wall size of 1.6mm using differents infill percentents in the slicer software: - 20% default infill is insuficient, cone breaks easely - 100% infill makes a rigid and breakable cone. - 80%/95% is the best configuration that I found. There is an optional bottom support called "bottom_ring" it's commented in the code. I think it is not necessary.