Ronin mk23

cults3d

This kit has been created for the socom mk23, it has been tried and tested in airsoft games. Designed for people who want to give a touch more to their replica, as this well upgraded replica makes long distances and can be used as a submachine gun or even assault rifle. It consists of a front part that would be the handguard, a rear part where it would be attached a standard stock tube 35mm in diameter with your respective stock to choose by the player, (both things not included in the kit), we would continue with a rail that would go from end to end of the Ronin fitted by a guide and 4 screws and 3 smaller rails that would go two on the sides and one at the bottom as shown in the photos. For assembly it is necessary to rework the 4mm holes which should be reworked with a 5mm tap. Necessary screws: 10 pcs M5X10mm 1 Unit M5X40mm 1 Unit M5X70/80mm(depends on each stock tube) 1 M5 Nut The assembly is very simple, print the parts and sand them to taste (depends on each filament + paint if you wish), go over the holes with M5 male, fit the nut in the recalada, and screw the stock tube, assemble the rear part and put the pin (screw M5X40mm), we continue with the front part, screw the rails in their respective positions (they are all aligned the two sides are different from the bottom), fit the handguard through the guide, (Attention, remove the muffler before and then put), move to the top rail that will enter through the guide and screwed into their respective holes the screws and ready for combat!! It may seem long but it assembles and disassembles quickly. Very important, it is necessary to have a minimum base of 30X30 for the larger rail print it crosswise. If you have any questions, don't hesitate to send me a message.