Rope Pull Handle

thingiverse

This is a pull handle, it features a 2 finger hold and a .25" through hole. I printed mine at 100% infill in PLA and no supports. I went with a solid fill part for 2 reasons, 1 I was printing it in PLA and 2 because it is going to be used to pull down a heavy attic door. You may be able to get away with less infill with PETG or tougher material. I also recommend printing it in its current (Flat) orientation for layer strength. I didn't use supports and it worked ok except for the lower beveled layer not perfect, but usable. I would use supports next time though no supports in the through hole.