Rose petal flower pot

thingiverse

I found a design of bucad, Rose Flower Pot http://www.thingiverse.com/thing:810720 , and found it quite pretty. However, I wanted more space for the flower and soil. Therefore I utilized the old design and created a remix with more space inside. The inner ring of petals are positioned to create a waterproof layer, so the walls of this flower pot should not leak (unless watered too full). I added some filling in between the petal layers to make it more durable. Print Settings Printer: Kossel XL Rafts: No Supports: No Resolution: 0.2mm Infill: 15% Notes: My setup: Delta printer with linear rails, Repetier firmware PLA 1.75mm (eSUN) Nozzle 0.4mm Brim 6mm Perimeters 3 Solid layers at top&bottom 3 Which takes approximately 48m filament. Post-Printing After printing I just spray painted the pot.