Rostock plywood SCAD dxf for laser cutting

thingiverse

I took Nudel_P scad file and modified it for use with laser cutting acrylic with holes for a mk1 pcb heatbed, printrboard, and l-brackets for the corner support. A notch was made in the corner for running wires from the top switches down to the base. Images shown still have the protective paper on them. l-brackets are from here:http://www.thingiverse.com/thing:2226 Marking this work in progress until it is fully built. UPDATE 10-20-2012: It is up and running (no longer in progress). Ended up using particle board for the side pieces for extra stability from added weight. The acrylic was too flimsy. Instructions Send one of each (top and base) to a laser cutter (using mm for units) and assemble. scad is documented if you need to adjust for different electronics ect. Same scad file is used to create the top and base. A switch is used at the top of the file to indicate type.