Rostock reused effector and carriage magnetic solution

thingiverse

This is a magnetic effector and carriage solution where you will reuse your effector, carriages and rods. You only need to print some small holders for the magnets and steel balls. I found some good solutions here on Thingiverse but none that's reusing the original Rostock effector, rods and carriages. That's why I made these things. magnet_holder.stl is for 12mm diam magnets like these:http://www.ebay.com/itm/161715991828 magnet_holder_15.stl is for the bigger and maybe stronger 15mm diam magnets like these:http://www.ebay.com/itm/381565838030 If you are using different sizes of magnets make sure they have the same height so the rods length will be even. ball_holder.stl is for 10mm diam steel balls like these:http://www.ebay.com/itm/371321207385 Further more you need 12pcs M4x14mm screws to mount above steel balls I used my glue gun to attach the magnets I reused the m3 screws and nuts to mount the magnet and ball holders, that earlier mounted the rods.