Rotary Clothes Dryer Plastic Details (Torkvinda)

thingiverse

Replacement plastic parts for a rotary clothes dryer. Parts: * Pole cap * "Cross holder" Dryer measurements: Rod/pole outer diameter: 40mm Width of "arms": 15mm (for the slots in the holder part) The pin/screw holes in the holder are made for 4mm screws (hole diameter is 5mm). I will put in bolts and screw on nuts on the other end. The cap was made with some guessing, but it fit OK on the dryer. It should fit a pole with inner diameter of 30-34mm (and possibly smaller) To remove the old cross holders, it is easiest to lower the lowest cross holder on the pole to just above the ground and then cut the metal pins using a reciprocating saw. Then flip the pole and do the same thing to the other cross holder. The pole helps stabilizing while cutting.