Rotring ArtPen replacement body

thingiverse

I bought a set of ArtPens which included three different tip widths, but only one body (the typical calligraphy sets sold by Rotring or other manufacturers). As I didn't always want to unscrew the body to use one of the other tips, I made two extra ones. Instructions Printed two of them at 0.09 mm layer height, 100% infill at opposite sides of the print bed to get some time for the layers to cool down. Nevertheless, it was a difficult print, but I'm quite happy with the result. As there is no thread in the body, I put a layer of thin adhesive tape on the thread of the tip to get a tight fit without the danger of destroying the very fine thread.