Router Table Infeed Guide (Jess-Em)

prusaprinters

<p>I designed this infeed guide to work with a router table I built using Jess-Em components. &nbsp;It requires three 1 inch ¼-20 bolts, a 608 skate bearing, and a couple of o-rings that fit snugly on the outer ring of the bearing. &nbsp;The nuts go in the knobs and a couple of drops of super-glue is handy here. &nbsp;I had to try a few different o-rings before I found some that were the right size and had a little sponginess to allow them to work well. &nbsp;Included is a small shim that goes inside the 608 bearing to adapt it to the bolt diameter. &nbsp;I also included a left hand guide plate.</p>