Row of 4 Pogo Pins

thingiverse

I needed to connect to a Sonoff T2 to flash it with Tasmota. Following the same plan as my other pogo pin programmer I made this one. To ensure proper connections to the open pin holes I used [these](https://www.amazon.com/gp/product/B07TS5KCXH/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1) I used a tiny clamp to hold it to the board but you can probably do without if you don't have one. Printing: You could probably print it either laying down or with the open holes facing up, I printed it laying down. I did need to clean out one of the holes a tiny little bit but otherwise worked great. The heads of the pins should fall right back into the body so that it sits flat on the circuit board.