Royal Claymore for small printers

thingiverse

This is the royal claymore for small printers that I cut in Blender. I included pieces for the handle that are cut in half labeled 'Sliced' so it can lay flat against a wall if that is your intention. 'Blade detail 6' and the 'hylian shield' are not included in the files because blade detail 6 was relabeled to 'in_blade' and hylean shield was relabeled to 'Up_Guard'. For Up guards 9 and 10 you might have to rotate them in your slicer, depending on how big your print bed is. This should take around 3kg of filament for the full sword, possibly more. I only printed half of it to hang on a wall, and it took about 1 1/2kgs. Should take around 100 hours blade alone if you plan on doing both sides, and if you're only doing half, it should take a little more than 100 hours for the full thing on the lowest quality i could print on (0.28). I also recommend printing Blade 1 at a higher quality to make sanding easier. Happy printing!