Runcam Hybrid 4K Pan/Tilt

thingiverse

Here's the pan/tilt mount I used in this video: https://www.youtube.com/watch?v=TARXprDY2DE You'll need some various bits of hardware to assemble it. The screws included with the Hybrid are a bit long, I used some little plastic washers from other FPV cameras I had sitting around on those. The M3 screws that attach the main board and cover are some countersunk ones from some other cameras that were on my bench, I'm not sure which one that came with. Either one of the older Splits or something else. They're not really critical in length though, just M2 scews long enough to reach through the cover and board into the base. The base is attached to the pan servo wheel using small self-tapping screws, I just used the wheel as a "template" to drill small pilot holes. The camera piece is attached to the base using two M3 screws, use ones long enough to thread into the camera piece snugly enough that they fit tight and won't back out, while still allowing the camera to tilt without too much friction. I printed this one in PLA, so it was a little more rigid than PETG, though I think this design would work equally as well in PETG with the added bracing in the base to stiffen it up. If you try it, let me know! The tilt linkage is the same M2 ball links from Banggood that I've used on a few other pan/tilts lately. Anything similar will work if you have something on hand, anything larger will likely be a bit big though.