Runcam Nano 3 Canopy and Mount

thingiverse

I wanted a canopy for the new Runcam Nano 3 so I made one, I have different versions I am working on but the "half canopy" version is finished since I am posting it. My canopy and mount come in at 1.4 grams, the original Mobula 6 canopy, mount, and foam come in at 1.1 grams so I am not much heavier but you do not need a piece of foam under mine as I use the front screw Put a screw by itself in the back FC screw hole then use the front 3 FC screw hole points to mount this canopy. The mount uses 2 m2 screws on the side and a couple 1mm screws to hold the camera. The mount I made will let you mount the Nano 3 in any 14mm canopy but the lens is so short it doesn't fit well. Print the canopy out of TPU Print the mount out of something hard like PETG, or PLA, reason being it will hold the screws from the canopy better so it stays at the angle you want after a few crashes, make the mount out of TPU and it will probably slip on the screws and change the angle in a crash. I have the mount on it's side for a reason to make the side screws as strong as possible. Use supports on both.