RunCam Split mount

thingiverse

What up snitches, this is a mount designed primarily for the RunCam Split. when you get the cam you'll notice the mount it comes with, works.... in a perfect world. So when I recieved it and got all excited to install it I noticed that there was no way on gods green earth it was going to function. Sooo i searched on here and found a few mounts that all provided the same issue, the issue being i end up getting allot of the frame from the quad in the picture. This design i made is to fit the Butter kwad from impulse RC ( http://store.rotorriot.com/pre-built-butterkwad-alien-by-impulserc/ ). This design gives you a 30 degree angle that is what is mostly used for all these quads. I kid you not you print this with zero support and use the screws that are provided to you in the RunCam split, bolt the camera on and slide the frame over the quads support frame ( tolerance is high so slowly work the 3d frame evenly on the quads support and you'll notice an awesome fit) and you are done. 1. It clears the frame 2. the holes are designed at 30 degrees and they are pre installed. 3. The frame works on the RunCam swift and Runcam mini :-)