RX5808 Case for Fatshark Dominators

thingiverse

For those of us on a Budget who can't warrant spending the money on a set of La Forge modules for our Fatshark goggles. This is designed to take the RX5808 module below:http://goo.gl/YYf0zG I printed mine in ABS with the settings below and used Acetone vapour smoothing to smooth the surface. Infill = 100% Layer height = 0.3mm Support = Yes Beware the side you attach the OLED as I attached mine on the side which mean the control was to the right as you look at it. The Inside and Outside can be screwed together, although I had to hot glue mine as I couldn't get screws to use and got impatient. I then used double sided foam to attach to the Goggles, so it can therefore be removed without leaving a mark. I use a Immersion RHCP Mini patch:http://goo.gl/z8itnO and an Omni Directional RHCP Antenna like an Aomway antennahttp://goo.gl/Zfopeb